sleeve bearing

The structure design, processing technology and industrial test result of shaft sleeve and bearing made with ultra-high molecular weight polyethylene ( UHMWPE) instead of copper and so on were introduced.

介绍采用超高分子量聚乙烯替代铜等制造轴套、轴承的结构设计、加工工艺及工业性实验结果。

In this paper the elastohydrodynamic lubrication of water-lubricated rubber sleeve bearing is examined.

本文对水润滑橡胶套筒轴承进行了弹流润滑分析。

Damage Reason of the Thrust Face of Sleeve Bearing on Motor Used in the Multi-stage Pump

多级泵电机轴瓦止推面烧损原因分析和对策

Where sleeve bearings are used, bearing shells shall be replaceable without removing pump or motor shaft.

那里套轴承的使用, 轴承壳应更换而不删除泵或电机轴.

Yoke Sleeve aluminum-bronze yoke sleeve minimizes operating torque. Larger sizes have needle bearing type thrust bearings.

轭架套管–铝青铜轭架套管最大程度减少操作扭矩. 较大通径的截止阀配置针形轴承类型的止推轴承.

Study on surface roughening and wearing of the oil-film bearing sleeve

油膜轴承锥套表面拉毛磨损的特征分析

New rise and descent systems were designed. After slip column and slip sleeve were substituted for axle bearing and orbit, failure vanished, utilization ratio of equipment and quality of products were raised.

经分析研究，发现故障产生的原因是结构不合理，通过重新设计计算，采用滑柱滑套结构替代原轴承和导轨条结构后，原有故障形式被消除，大大提高了设备利用率和产品质量。

The Principle and Processing Technology of Oil Film Bearing as Well as the Grinding Method for The Common Grinding Scar of The taper Sleeve and Bush

油膜轴承原理及加工工艺及锥衬套常见研痕的一般修磨方法

Because it is difficult to withdraw sleeve for cylindrical full-roller bearing, the bearing structure is analyzed, the roller of bearing is grinded with mechanic processing method, then withdrawal sleeve can be smoothly realized.

针对圆柱满滚子轴承拆套困难问题，对轴承结构进行分析，并用机械加工方法对轴承内的一粒滚子进行磨削，使其能够顺利拆套。

Because of its superior performance, the friction in friction application fields become best material, such as sleeve bearing, sliding bearing, the valve seat, seals, pump wear ring, etc.

因其优越的摩擦性能，在摩擦应用领域成为理想材料，如套筒轴承、滑动轴承、阀门座、密封圈、泵耐磨环等。

One sleeve and one ball bearing life expectance: 30,000 hours minimum.

一个含油轴承和一个滚珠轴承预期寿命: 至少30,000小时.

Technological Practice on Bearing Sleeve Grinding Using CBN Grinding Wheel

用CBN砂轮磨削轴承套的工艺实践